Outdoor waterproof knog 400 background light, manufacturing and aging test process
Product type:outdoor Blinder Light
Voltage: 90-240V 50/60Hz
LED: 4pcsx 100Watt Warm white COB LED (pixel)
Beam angle: 70 degree (Sharp beam effect)
Dimmer:0-100% linear dimmer
Strobe:1-25timesc or random strobe
Variable run method,jump change,Gradual change
4 LED have different run method
DMX channel: 1/2/4/8CH Operate mode:Auto run,master/slave,
sound active,dmx 512
indicators:led display
connector:powercon in/out
dmx in out:3pin waterproof rate:IP65
work environment:outdoor use
housing case:metal 55x84x59cm 4pcs/flight case
What is the difference between outdoor background lights and indoor background lights
The difference between indoor and outdoor luminaires used in background Indoor luminaires: no waterproof/drip-proof requirements, the power cord of the luminaire is generally PVC wire. Outdoor lamps and lanterns: there are waterproof/drip-proof requirements, depending on the specific installation location, and dust-proof requirements, the power cord of the lamp is generally a rubber wire. Specifically, we have to look at which lamp, they all have different standards.
What is the difference between indoor and outdoor background lights
Installation: The installation will withstand wind and rain. If 3M glue is used to fix it, the 3M glue will decrease over time and cause the LED light strip to fall off. Therefore, the installation often uses a card slot to fix it, and it needs to be cut and connected. The method is the same as indoor installation, except that it needs to be equipped with waterproof glue to consolidate the waterproof effect of the connection point. Indoor installation: When LED light strips are used for indoor decoration, they do not have to withstand wind and rain, so installation is very simple. Take the LED lights produced by Zhongshan Mingjian Lighting as an example. The back of each LED light strip has a self-adhesive 3M double-sided tape. When installing, you can directly remove the sticker on the surface of the 3M double-sided tape, and then fix the light bar on the need. Just press it flat by hand for the installation place. As for some places where corners are needed or if it is long, what should I do? Very simple, the LED strip is a circuit structure composed of 3 LEDs in series and parallel, and each 3 LEDs can be cut and used individually.
